|Supplier||Intraco Hardware (M) Sdn Bhd|
|Address||1, Jalan Kilang 51/206, Seksyen 51, 46050 Petaling Jaya, Selangor, Malaysia Malaysia|
MPN No. (ITEM CODE):
SELLEYS Acrylic Wall Sealer 1L
Seals, conditions and unifies surfaces, to provide a suitable foundation upon which the top coats can be applied. It is formulated with 100% acrylic polymer, premium grade titanium dioxide pigments and special mineral fillers and additives, to ensure adhesion and performance of subsequent topcoats.
**Weather resistance – Suitable for exterior application when topcoated.
**Heat resistance – Resists up to 90°C when topcoated.
**Solvent resistance – Resists aliphatic hydrocarbons, sensitive to alcohols and strong solvents.
**Water resistance – Resists rain and condensation when topcoated.
**Abrasion resistance – Resists abrasion when coated with high performance topcoats.
**Resistant to growth of algae, moss & lichen in well-ventilated areas when coated with high performance topcoats.
**Solids by volume: 30%
**Application method: Brush, roller or spray
**Thinner: Not recommended
**Clean all equipment with water
**Water based. Lead free. Dry film is non-toxic
**Touch dry: 30 minutes
**Recoat: 2 hours
**No of coats: 1
**Surfaces must be cured, clean and free of contaminants such as from oils, release agents, mortar splashes, mould and algae. Surface imperfections must be patched and ‘flush’ to surrounding surfaces. Metal, tie wire, embedded nails etc, must be removed or treated against corrosion.
**The product is ready to use. DO NOT THIN. Use a regular nap, roller sleeve to apply the wall sealer to the substrate. On walls, commence floor to ceiling and on ceilings work across the shortest width. Brisk uniform and continuous application is essential to maintain a wet edge and ensure an even coating before the material starts to dry. Apply wall sealer at 10°C to 30°C. Avoid application in windy conditions or in full sun, especially on large areas. Protect from rain and frost for the first 24 hours.