|Supplier||Intraco Hardware (M) Sdn Bhd|
|Address||1, Jalan Kilang 51/206, Seksyen 51, 46050 Petaling Jaya, Selangor, Malaysia Malaysia|
DULUX Pure;Line Base A;1L;Code:A907-A(DSPUBA 1L/5150253)
-Anti-Bacteria,Mould & Fungus resistant
-Complies with JC/T 1074-2008 "Purificatory performance test method of coatings on air purification"
-Low VOC, low odour,Virtually no paint smell during painting,keep air fresh after painting
-Low sheen finish
-Washable & easy cleaning
-Keeps colours looking fresh longer,smooth luxurious finish
Model No. (BARCODE):
MPN No.(ITEM CODE):
Coverage: 12m² / L
Number of coats:: 2 coats
Drying time; Single coat at standard thickness:
Touch Dry: Dependant on temperature and humidity.
Recoat: 1-2 hours.
Preparing the surfaces: Surfaces must be sound, clean, dry and free from all defective or poorly adhering material, dirt, grease or wax and be thoroughly rubbed down using a suitable abrasive paper and dusted off. It is important to ensure that your wall is smooth and even to obtain the best results from Dulux Pure.Treat areas affected by mould, fungi or algae with Dulux Fungicidal Wash (A980-19260). If after thorough preparation, surfaces remain powdery, seal with one coat of an appropriate Primer (see below). It should not be applied on areas where moisture reading (as measured by Protimeter) exceeds 17%. These wall should be left to dry further.
Painting: Roller or brush
Cleaning: Clean all equipment with clean water immediately after use.
Storing: Keep away from food, drinks and animal feed. Store in a cool and shaded place.Container must be in a secure, upright position and be tightly closed.
Recycling: Avoid release to environment. Refer to special instructions/Safety data sheet. Do not empty into water course. Dispose of used container in compliance with local regulation.
Health and Safety: Keep out of the reach of children. Do not breathe vapour/ spray. Use only in well ventilated areas Safety data sheet available for professional user on request. Avoid contact with skin or eyes If swallowed seek medical advice immediately and show this container or label. Dry sanding, flame cutting and/or welding of the dry paint film will give rise to dust and/or hazardous fumes. Wet [sanding]/[flatting] should be used wherever possible. If exposure cannot be avoided by the provision of local exhaust ventilation, suitable respiratory protective equipment should be used Do not use empty container for storing food. Remove as much paints as possible from brushes and rollers before cleaning. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. In case of contact with skin wash immediately with soap and water or a proprietary skin cleanser. Do not use solvents or thinners. Wear eye/hand protection. Refer to Dulux Product Safety Data Sheet for further details.